When using flatbed dump trailers, if you encounter a failure, how to solve it? As a manufacturer of shed-type trailers, let the editor take you to understand the causes of failure of flatbed dump trailers!
(1) The car body is difficult to lift. The main reason is the lack of oil in the fuel tank. One is that the fuel tank filter or pipeline is severely blocked; the oil pump is faulty; no oil supply; the lifting switch (open to the atmosphere) is blocked, and the return valve of the distribution valve is stuck in the return valve position; the overflow valve is severely out of adjustment, and the high-pressure oil pump is leaking; the lifting cylinder and the limit valve are stuck, so that the air path to the distribution main valve is connected for a long time; and the air pressure of the air tank is insufficient; the power take-off and oil pump gears are not working properly; the hydraulic oil is not clean, and impurities are stuck in the distribution valve. When judging, if the pipeline in the hydraulic system is blocked, check whether the oil inlet, return port and tank filter are blocked. If the hydraulic oil is too dirty, replace it with new oil; clean the filter to see if the oil circuit is unobstructed; second, the distribution valve stem is severely worn, which increases the clearance between the valve stem and the inner hole of the valve body, causing the high-pressure oil pumped by the gear pump to leak back to the oil tank from this gap. At this time, it should be replaced and re-matched and ground.

(2) The car lifts slowly and weakly with movement. Air enters the hydraulic system, which is usually caused by blocked return oil circuit, excessive friction resistance of the lifting cylinder, loose or misaligned lifting cylinder limit valve, loose sealing of lifting cylinder seal ring, reduced operating efficiency after wear, insufficient oil in the oil tank, failure of the gear pump to reach the specified oil discharge volume, and severe blockage or leakage in the pipeline. First, check whether there are a lot of bubbles overflowing from the liquid surface when the hydraulic oil tank is opened, and then tighten the joints of the gear pump oil inlet pipeline. Check the oil pipe for cracks, clean the hydraulic oil tank and filter, loosen the hydraulic cylinder oil inlet pipe nut to clear the air, and try to lift the cargo box to see if it is cleared. Otherwise, it may be that the hydraulic oil pump oil seal is leaking. Replace the oil seal if necessary.
(3) The heavy load cannot be lifted. Most of them are caused by severe overloading; the vehicle is parked on a broken road that is severely tilted forward; the oil viscosity is too low; and there are leakage problems in the pipeline, valve, and cylinder.

(4) The car body falls by itself after being lifted. Most of them are caused by the one-way valve being stuck; the lifting cylinder seal ring is not sealed well; the distribution valve is stuck and not fully in place; and there is leakage in the pipeline.
(5) The car body does not fall. Insufficient air pressure, the distribution valve cannot return oil; or the limit valve pipeline is damaged, and the lifting switch and lifting cylinder are stuck.
(6) The car body cannot be lifted and stopped at any position. This is mostly caused by the oil being too dirty, causing the check valve to not seal tightly, or the distribution valve and oil return valve to not seal tightly.
