News

Safe Driving Of Obstacle Clearing Vehicles

Mar 18, 2024 Leave a message

With the increase of high-grade road surfaces and in use vehicles, obstacle clearing vehicles have also been developed. However, as the development of obstacle clearing vehicles continues, some unsafe factors are inevitably occurring. Therefore, while paying attention to economic benefits, it is also important to pay attention to the safe operation of obstacle clearing vehicles. [2]
1. Before driving a clearing vehicle to reverse, one should carefully observe the reverse route and confirm that the conditions for safe reverse are met before reversing. During the reverse process, drive slowly, pay attention to the situation on both sides and behind the clearing vehicle, and always pay attention to the spatial position on both sides of the front of the vehicle. Be prepared to park at all times to avoid collision accidents caused by excessive steering angle. Even if the road conditions behind are good, do not accelerate or reverse.
2. On general roads, reversing should avoid busy traffic, non motorized vehicles, and narrow road sections with more traffic. When reversing, if you find passing vehicles, you should take the initiative to stop and avoid them. When making a U-turn that requires reversing, it should be done in a location that does not affect normal traffic.
3. If a clearing vehicle needs to make a U-turn, it should choose a wide road section with low traffic flow and no signs prohibiting U-turns. It is strictly prohibited to make U-turns in areas where U-turns are not allowed or on dangerous road sections. Before turning, the clearing vehicle should first observe the traffic situation behind the clearing vehicle to confirm safety.
4. During the process of turning the obstacle clearing vehicle, the speed should be strictly controlled, the situation in front and behind the road should be carefully observed, and only after confirming safety can the vehicle move forward or reverse, and be prepared to stop at any time. When it is necessary to turn around on a slope, the handbrake control of the cleaning vehicle should be used every time the vehicle stops to avoid accidents caused by the sliding of the cleaning vehicle.

Send Inquiry